hugenostrils
Member
- Messages
- 4
I have one of these tig units and also a Thermal Arc foot control with the plug missing. Does anyone have a wiring diagram or any idea of how I should wire the plug.
Thanks
Dick
Thanks
Dick
Many thanks. I will give it a try.
Dick
I have found it very good - I use it mainly for light mild and stainless. It does'nt get heavy use. I paid £175 for it about 6 years ago - it had just had the circuit board replaced. £70 sounds like a good deal.
Dick
I have found it very good - I use it mainly for light mild and stainless. It does'nt get heavy use. I paid £175 for it about 6 years ago - it had just had the circuit board replaced. £70 sounds like a good deal.
Dick
Add another zero
BUT is it still a good deal at that. Obviously I would love a LORCH and a PORTAMIG to get the best of both worlds BUT finances wont stretch to this yet!
Time is also against me sadly.
No i wasn't saying it was expensive, Just pointing out that hugenostrils had missed a decimal place
I have lots of murex kit and have been well chuffed with it over the years, So the 151 shouldn't be any different