Mid Wales welder
Welder coding and NDT services
- Messages
- 662
- Location
- Powys, U.K.
Hi everyone! This is my first post as I am new to the forum. I have a quick question & hope I am writing this in the wright place. I'v been doing a job at work that requires alot of welding on 1.5 & 2mm stainless steel, my welder is a kempoweld 4000 with the 400 wire feeder, I'm using 1mm stainless wire & I am on the lowest setting possible. I'v tried every speed & technique I can think of & even though it's a good strong weld I just can't seem to get a nice neat weld. It also requires welding in all positions & the outside corner vertical down is just so hard i find that im chasing the pool all the time. Any advice would be much appreciated! Thanks