malcolm
& Clementine the Cat
- Messages
- 9,633
- Location
- Bedford UK
Been sharpening a rotary mower blade today, but it was so far gone it was difficult to see what the profile of the cutter had looked like.
The obvious would be taper to a sharp edge with the bottom of the blade flat, but that's going to wear quickly. Also the blade looks like it might have had a squared off leading edge in the past. Anyone know what sort of profile the blade should have?
The obvious would be taper to a sharp edge with the bottom of the blade flat, but that's going to wear quickly. Also the blade looks like it might have had a squared off leading edge in the past. Anyone know what sort of profile the blade should have?