Moisture coming from plasma torch

[Thebeast]

I have a plasma cutter with a built in compressor. On the back of it it has a water trap air regulator. It was fine but I haven’t used it for a month or so and today when I was trying to cut a 5mm sheet it wasn’t cutting all the way through and I went through about 4 tips doing a cut 1m long. There’s a lot of moisture coming out when the air is blowing through. How do I remove the water/moisture out of the torch cable I tried raising the torch lead up and more moisture comes out but it’s still burning all the tips up :/

Any advice would be appreciated

 

[gaz1]

if near your house stick the plasma torch on the rad will dry it out fully

as goes for water check your trap and you might need another different type of trap to catch more water

optima i think had a good reference for water absorbshone

 

[Erie Fred]

I have a plasma cutter with a built in compressor. On the back of it it has a water trap air regulator. It was fine but I haven’t used it for a month or so and today when I was trying to cut a 5mm sheet it wasn’t cutting all the way through and I went through about 4 tips doing a cut 1m long. There’s a lot of moisture coming out when the air is blowing through. How do I remove the water/moisture out of the torch cable I tried raising the torch lead up and more moisture comes out but it’s still burning all the tips up :/

Any advice would be appreciated

What machine ?

some pix of the moisture filter might prove helpfull as well.

 

[Barking Mat]

Have you emptied the water trap ?

 

[Thebeast]

Have you emptied the water trap ?

Yeah mate

 

[Thebeast]

What machine ?

some pix of the moisture filter might prove helpfull as well.

Cheap one mate static arc it’s called I got it from Amazon I would have to send photos tomorrow

 

[Erie Fred]

Cheap one mate static arc it’s called I got it from Amazon I would have to send photos tomorrow

Did you remove the bowl, and make sure it's clean ?
Is there a decisant filter as well ?

Might find a loose or errant comma lying in there as well......