I am adpating my welder to use fluxed wire as well as gas as suggested by Jan here.
While I am doing this, is there any way that I can make changes to it, perhaps adding parts from a similar machine, to allow me to adjust the voltages more than the current two settings and, ideally, reduce the lowest current?
Any other suggestions for improvements would be appreciated as well.
Regards,
James.
While I am doing this, is there any way that I can make changes to it, perhaps adding parts from a similar machine, to allow me to adjust the voltages more than the current two settings and, ideally, reduce the lowest current?
Any other suggestions for improvements would be appreciated as well.
Regards,
James.