hello all,
i'm no toolmaker, so this may be a stupid question!
i'm looking to mill a 35mm wide by 12mm channel through the centre of some 2x3/4" brass flat, but it needs to be done the entire length of a 3000mm bar. I'm assuming this just means having to re-clamp the work piece after the head has travelled as far as it can?
is this correct or am I an idiot?
cheers!
i'm no toolmaker, so this may be a stupid question!
i'm looking to mill a 35mm wide by 12mm channel through the centre of some 2x3/4" brass flat, but it needs to be done the entire length of a 3000mm bar. I'm assuming this just means having to re-clamp the work piece after the head has travelled as far as it can?
is this correct or am I an idiot?
cheers!