Mig welding questions

[Gsg_48]

[td]

[td]

Hi ,what is the best way to connect spool gun to a Mac 180 mig welder​

Do you break into wiring for diverter electrical switch at the gas valve and wire drive electrical motor directly rather than the circuit board,
Also where can you purchase small surface mounted socket and plug to connect spool drive/gas power also 2 way electrical switch
Are there any dangers to not blow circuits!!!!
Any other ideas would be great fully received
Regards Geoff​

[/td]​

[/td]​

 

[BrokenBiker]

Don't know of its just because I use dark mode, but I can barely see whatever you have attached there...

Something about a spool gun?

The spool gun replaces the torch...you shouldn't have to cut into anything just disconnect the torch and connect the spool gun the same way