C clairetoo Member Messages 64 Dec 18, 2012 #1 Just a quicky - would there be any problems mig'ing CDS tube - 1 1/4 dia/ 2mm wall ? The spec is BS3623 Part 4 CFS3 BK Mechanical - its all I can get to finish a job before Christmas , the rest of the job is in normal seamed mild steel tube .
Just a quicky - would there be any problems mig'ing CDS tube - 1 1/4 dia/ 2mm wall ? The spec is BS3623 Part 4 CFS3 BK Mechanical - its all I can get to finish a job before Christmas , the rest of the job is in normal seamed mild steel tube .
pedrobedro Man at Matalan Messages 13,116 Location CX near Chesterfield Dec 18, 2012 #2 I made wishbones from CDS 25x2mm and mig welded without any problem.
chevy2 Member Messages 1,631 Location Herts. Dec 18, 2012 #3 You shouldn't have any problems by mig welding cds.
Shox Dr Chief Engineer to Carlos Fandango Messages 18,010 Location East Yorkshire Dec 18, 2012 #4 Well its streets ahead of the stuff you have been using, so not a problem
