Mince and tatties
Member
- Messages
- 45
- Location
- Scotland
I’m new to the fabricating scene. I’ve recently just started a new job for an engineering firm as a learner.
I got asked to Mark out holes for 80 pieces of 50x50x3mm box section. Each piece of box section has two holes to be drilled, the hole centre is marked at 25x25mm inwards from either edge of the box section leaving a 50mm pitch between the two holes.
instead of marking them out individually is there anything I can make like a makeshift jig to speed the process up. If so then how should I go about doing so?
I got asked to Mark out holes for 80 pieces of 50x50x3mm box section. Each piece of box section has two holes to be drilled, the hole centre is marked at 25x25mm inwards from either edge of the box section leaving a 50mm pitch between the two holes.
instead of marking them out individually is there anything I can make like a makeshift jig to speed the process up. If so then how should I go about doing so?