M16 45mm o/d diamter, 2.4mm thickness, stainless washers

[RaceDiagnostics]

Does anyone know where I could get washers this size?

Edit, perhaps its not an M16, I need as the I/D to be 16mm.

 

[The_Yellow_Ardvark]

http://www.kameng.co.uk/

http://hiscockengineers.co.uk/

give them a shout, they may be able to help.
Or point you in a direction.

 

[RaceDiagnostics]

After a lot of googling it seems to be a non standard size so I'll try to make them out of this lump tomorrow.

 

[RaceDiagnostics]

First time I have used a lathe for 35 years!

I found another bit of bar 44mm in diameter which is close enough.

Drilled out a 16mm hole.

Then parted off eight washers.

Needed to clean off a lip from the parting tool.

Job done, shouldn't have to worry about these rusting.

 

[eSCHEn]

Neat and tidy