magnusk750
New Member
- Messages
- 12
- Location
- Estonia
Yesterday I got the welder working. Bought it a few years ago, but never hade the time or space until now. Set up with 0,8 wire and mix gas, but difficult to get the settings right on sheet metal. There are charts in the manual with sample settings, but in general, when I went by the chart it didn't burn the material, only produced 'birdshit' on the surface. Applied more current, but then again it burnt through very quickly. On thicker materials I could sometimes come to a nice buttery feel with almost no spatter
Is there a defined way to achieve the right settings? On most mig welders there's only two parameters, current and wire feed. Here it's four, backgroud current, peak current, wire feed and hot start, difficult to know which one shoud be adjusted.
Is there a defined way to achieve the right settings? On most mig welders there's only two parameters, current and wire feed. Here it's four, backgroud current, peak current, wire feed and hot start, difficult to know which one shoud be adjusted.