roblane65
Member
- Messages
- 2,147
- Location
- Newcastle UK
The choice was made for this machine when I got an offer through ebay for over £50 of the listed price So I hit the button.The welder arrived today and first look appears good, fit and finish appear good, its got 35-50 dinse sockets comes with a heavy power cord and a nice adapter to uk 13 amp plug. I may change this to a 16 amp at later date when I've sorted the garage electrics . 3m ground cable with a decent clamp with copper blocks and a decent length of heavy gas pipe with regulator fitting pre clamped ,As well as the standard controls there is also an inductance control which i've never had on welder before. So i'll have fiddle with that when I set it up tomorrow just mig for now ( no tig torch or stinger supplied ) I'll give the clarke a check over and get that ready to to go to a new home then have play with new one. the only downsides so far are the torch does seem a bit chatty for the cost and no 0.6 roller if I want to go to lighter wire.
Hopethis is in the right section fairly new to the forum
Hopethis is in the right section fairly new to the forum