Knife Grinder

[Parm]

Hi folks, got this water cooled grinder which works a treat.as well as the main wheel that is visible in the picture there is a secondary wheel to the right of the motor assembly used for primary grinding

This is worn away and needs to be changed. Size of the wheel is 102x13x20 mm and it's rated to 6000 rpm.

I've taken the wheel out and it's made by Norton and called a Normax, other markings have scrubbed off.

Where can I get a replacement from? Any help muchly appreciated

 

[GrahamGKD]

Would something like this one from AbTec work (the hole is slightly smaller than your 20mm?)?

 

[Parm]

Would something like this one from AbTec work (the hole is slightly smaller than your 20mm?)?

That's the one I've been looking at, to make it work I will need a new locating bush to be machined up that will fit 19.05 bore size. I've asked a mate to make me one