Richie Plewka
New Member
- Messages
- 16
- Location
- West Sussex, UK
I recently acquired a Kemppi ProMig 530 Synergic that has a fault - Err 12 which I'm lead to believe is a problem with the main board, yet to diagnose...
It came with a Pro 5200 power source which I'm told is fine.
My problem is I don't have a 3 phase supply so can't switch it on to witness the error code and start to have a probe around.
So, my question is does anyone have any technical information about the ProMig 530? Circuit diagrams, connector diagrams, anything really.
My thinking is that if I can hook the ProMig to a 50VDC supply, it should power up and allow me to have a play (not weld obviously!) and start to workout what's wrong. It's not obvious the which pin is which on the power supply connector - can anyone help?
Thanks
It came with a Pro 5200 power source which I'm told is fine.
My problem is I don't have a 3 phase supply so can't switch it on to witness the error code and start to have a probe around.
So, my question is does anyone have any technical information about the ProMig 530? Circuit diagrams, connector diagrams, anything really.
My thinking is that if I can hook the ProMig to a 50VDC supply, it should power up and allow me to have a play (not weld obviously!) and start to workout what's wrong. It's not obvious the which pin is which on the power supply connector - can anyone help?
Thanks