Any idea if anyone flogs suitable, dimpled plates for use under jacking screws when installing machinery?
We can make our own - say about 100mm square, 8,10mm thick, with a divot/dimple/end of drill mark somewhere close to centre (premium version - stops them squirming out as you wind the screw), but if someone's churning them out by the thousands, it's got to be cheaper than our hundreds.
When final installed, and bolted down, spacer under the machinery will be grouted to take the loads properly.
We can make our own - say about 100mm square, 8,10mm thick, with a divot/dimple/end of drill mark somewhere close to centre (premium version - stops them squirming out as you wind the screw), but if someone's churning them out by the thousands, it's got to be cheaper than our hundreds.
When final installed, and bolted down, spacer under the machinery will be grouted to take the loads properly.
