Identify very thin cable need to replace

[angellonewolf]

I've got a dewalt green lazer looks not even used bought it as a project only thing I've found is one of the hairs breath cables are broken i need to find out what type of cable these are

The cable

The cable measures .05mm

And I'm assuming it's insulated as well ? As they got throught the same hole so a large chance they would touch

 

[500e]

Give me a pm with address will send you some foc.

 

[Kram]

That is enammeled copper wire, motors use it as single strand but if it needs to be flexible and resistant to vibration, earphone cables use the braided type. I'm unsure which from your pic but given that is broken, probably single strand.

Its not easy to solder. You need iron on 300c+ to burn off the insulation and tin it. It needs to be tinned before you go anywhere near that fine connection to the laser diode.

Lasers are very sensitive to heat. You need to be fast when you solder that.

 

[500e]

That's what I will send you

 

[angellonewolf]

thankyou @500e will pm you