- Thread starter ukracer
- Start date
All I need now is some kind person to photograph their hole cutter kit and I can make one of those to go with it. 
If all else fails this one is basic enough to make.
http://circleburn.com/
If all else fails this one is basic enough to make.
http://circleburn.com/
Maker
Most folk just call me; Orange Joe
- Messages
- 10,637
- Location
- Keeler crater
Miller?
the snooper
getting older by the day
- Messages
- 21,084
- Location
- Hull UK
All I need now is some kind person to photograph their hole cutter kit and I can make one of those to go with it.
If all else fails this one is basic enough to make.
pheww you had me worried when I got that far
gordon stephenson
Member
- Messages
- 7,468
- Location
- Skelton in Cleveland U.K.
I made a circle cutter quite a while ago, Search the forum for the posting.
Gareth0123
You'll need 16 pigs to do the job in one sitting!
- Messages
- 1,556
- Location
- Norwich, Norfolk, UK
One of these arrived in the post from China yesterday www.ebay.co.uk/itm/130840593293
It is fully adjustable from about r35mm through to about r435mm
I offered £12.80 plus the £7 P&P making £19.80 which they accepted, and it arrived within 12 days. So far I've only played with it in my new R-Tec P30, but it does work extremely well on 6mm durbar plate at r60mm and r200mm
You'll have to go to their ebay shop to check out the other circle cutters as the heads are specific to the torch shrouds. So just match the torch shroud that your plasma cutter uses and then cross reference the part numbers to get the correct circle cutter kit.... Simples!
P.S their consumables that I used in my old combined CT416 plasma cutter and tig welder were very well priced and worked exceptionally well without any problem.
It is fully adjustable from about r35mm through to about r435mm
I offered £12.80 plus the £7 P&P making £19.80 which they accepted, and it arrived within 12 days. So far I've only played with it in my new R-Tec P30, but it does work extremely well on 6mm durbar plate at r60mm and r200mm
You'll have to go to their ebay shop to check out the other circle cutters as the heads are specific to the torch shrouds. So just match the torch shroud that your plasma cutter uses and then cross reference the part numbers to get the correct circle cutter kit.... Simples!
P.S their consumables that I used in my old combined CT416 plasma cutter and tig welder were very well priced and worked exceptionally well without any problem.
Last edited:
You think I am made of money...lol No its an R-tech P50
Wallace
Member
- Messages
- 7,773
- Location
- Staines, Middlesex, England.
I never got the money...........THAT was my problem..With all that Tax money....
I have got the materials to make that when i finish my mini garage sorting/tidying..
