Guttepjokk
New Member
- Messages
- 1
Hello guys,
I recently bought a nearly unused Kemppi promig 530, with MXE panel! Trouble is that there's only a couple of curve selections on each metal (fe, al, ss, x) There should be lot's of selections e.g. "FE FC" FC = flux core!
Can anybody tell me how to get those curves and how to install them? I feel pretty sure that I need software and a file + interface to get to goal with this
I've tried "reset to factory settings" in sub menu, but with no luck. I think the service man may have stripped away all unnecessary curves
Grateful for all good advice
I recently bought a nearly unused Kemppi promig 530, with MXE panel! Trouble is that there's only a couple of curve selections on each metal (fe, al, ss, x) There should be lot's of selections e.g. "FE FC" FC = flux core!
Can anybody tell me how to get those curves and how to install them? I feel pretty sure that I need software and a file + interface to get to goal with this
I've tried "reset to factory settings" in sub menu, but with no luck. I think the service man may have stripped away all unnecessary curves

Grateful for all good advice