Hobart 125 loss of wire feed.

[Taylor43]

I JUST had my gas relay replaced and the welder has been working great but today i was welding the exhaust on my truck and the wire simply stopped coming but the gas was working fine. My first thought was that my spool of wire was empty or a clogged tip but with neither of those being the problem i think my drive motor has failed. I covered the wire drive motors electrical contacts in dielectric grease but its still not working. I used my test light and it seams the board isn't even giving off any power to the wire drive motor. Could of something else failed on the board? or is there anything else i could troubleshoot?

Thanks in advance guys!

RC1 Is the clip for the drive motor

 

[Jake SS]

Try rotating the voltage switch first to make sure it is in the "detent" position of all the positions, making good contact, as motor will not work if not contacting properly.