Hob removal

[Bryan Williams]

anyone know how these are fixed in? Can't see any clips ,screws ect ,is it just bedded on sealant?
I have turned power off at the consumer board.
Cheers.

 

[eLuSiVeMiTe]

Clips don't seem to have been fitted. Have seen them with sticky backed strips around the rebate before. Run a thin flexible scraper around it and see it it frees up.

 

[Bryan Williams]

Clips don't seem to have been fitted. Have seen them with sticky backed strips around the rebate before. Run a thin flexible scraper around it and see it it frees up.

Yep, it's out now, stuck down with clear silicone.

 

[cumbriasteve]

It's the lazy mans way to avoid getting under to fit the clips, although I always seal any I do to stop water getting under and reaching the cut surface of the worktop, a bit of the old belt and braces but if it's worth doing then as they say..do it right.