Hitbox 200 Mig Welder

[brading]

Does anyone know if or where I can get a 0.6 wire feed roller for this welder

 

[pedrobedro]

Are they square drive or keyed shaft, plenty of drive rollers on eBay and feeds are pretty generic.

 

[tigdlo]

For my generic chinese mig feed roller, I measured it and found one on ebay. The 0.8 roller I have will feed 0.6 wire through a 3m torch with no issues, still bought a 0.6 just incase.

 

[brading]

Are they square drive or keyed shaft, plenty of drive rollers on eBay and feeds are pretty generic.

Thanks for the reply Already checked out Ebay. The keyed ones on Ebay are 10mm centre bore, 30mm od and 10mm wide where my is a keyed drive approx 8.2mm centre bore, 25mm od and 7.45mm wide

 

[brading]

For my generic chinese mig feed roller, I measured it and found one on ebay. The 0.8 roller I have will feed 0.6 wire through a 3m torch with no issues, still bought a 0.6 just incase.

Thanks for the reply. I was going to try 0.6 wire with the 0.8 roller if I could not get a 0.6 roller.

 

[brading]

Tried 0.6 wire with a 0.8 roller and it just would not drive the wire.

 

[tigdlo]

Have you found the correct roller?