hello, my welder has a high and a low input for putting the rod holder cord. i recently put it to the high one, and it seems to really penetrate with a 6013 rod i like it, but can it be used with all kinds of rods, such as 7018. and what should the high setting be used for, and when.
- Thread starter 50mags50
- Start date
Drains
Yeah, nah.
- Messages
- 7,718
- Location
- Sefton, South Island, NZ
Hey mags. Has the welder got any other settings, eg amps?. If it has, then your high and low would be different voltages. Normally the high volt selection would be used for smaller rods, as your current will be have a lower range, or for special rods that require a high voltage - like some 70xx rods, some stainless, etc.
If it has no other settings then I guess it's just high amps and low amps. Post a pic of the set and you might get a better answer!
If it has no other settings then I guess it's just high amps and low amps. Post a pic of the set and you might get a better answer!
there is amp settings aswell
hello, there is high and low inputs, and also a lever u need to pull to release the machine then u move a "clock hand looking thing" from 40 amps at 100 percent dudy cycle all the way up to 295 amps at 20 percent and everything in between.
hello, there is high and low inputs, and also a lever u need to pull to release the machine then u move a "clock hand looking thing" from 40 amps at 100 percent dudy cycle all the way up to 295 amps at 20 percent and everything in between.
