hi I'm a newby

[Aldo 4636]

hi all I understand the basics been around the garage seen 4 years I'm have a clarke 151 te I'm going to be welding box mostly 4 now I no to make sure clean all surfaces to be welded an setting gas pressure I'm a bit unsure about wire feed speed an which thickness of wire to use thanks

 

[rtbcomp]

Welcome to the forum - not sure what the poll's about?

 

[Wozzaaah]

Me neither, I just voted any then deleted the poll.

0.8 mm wire, full power, set the wire speed so it starts to push the torch away then back it off until it doesn’t.