dan.taylor.1
General Tinkererer
- Messages
- 2,690
- Location
- Kendal, Cumbria
Hi folks,
A mate has passed me an older Morris chain hoist, 2t capacity, 3 phase unfortunately but I do have a converter.
However, it is missing a few bits and has a leak, leak shouldn't be too hard to fix, one seal and a gasket face to clean and seal up. It's missing the pendant which again isn't too difficult to make up or get from the usual suspects.
The main issues are it's missing the chain wheel from the lower hook block, and the retainer for the hook itself that goes on top of the thrust bearing. The pic below is from a smaller hoist I got in a job lot but doesn't work just to show the bits missing.
Does anyome have a source for the hook/block? Also any help with wiring the pendant (bottom choc block in the pic) as the thick wires and labelling have me confused..!
A mate has passed me an older Morris chain hoist, 2t capacity, 3 phase unfortunately but I do have a converter.
However, it is missing a few bits and has a leak, leak shouldn't be too hard to fix, one seal and a gasket face to clean and seal up. It's missing the pendant which again isn't too difficult to make up or get from the usual suspects.
The main issues are it's missing the chain wheel from the lower hook block, and the retainer for the hook itself that goes on top of the thrust bearing. The pic below is from a smaller hoist I got in a job lot but doesn't work just to show the bits missing.
Does anyome have a source for the hook/block? Also any help with wiring the pendant (bottom choc block in the pic) as the thick wires and labelling have me confused..!