Mark Davison
Member
- Messages
- 177
- Location
- London
I have a threaded back plate for lathe that is looking for a new home. It came on a 6" Pratt 4 jaw independent chuck that I bought off eBay a few years ago.
It appears to be a 2" x 4 TPI 60 degree thread. It could be 6mm, it is hard to get my short thread gauge in and to see at the same time.
The plain register is 2-1/16" (if it's imperial).
Any ideas as to what lathe this may fit?
It appears to be a 2" x 4 TPI 60 degree thread. It could be 6mm, it is hard to get my short thread gauge in and to see at the same time.
The plain register is 2-1/16" (if it's imperial).
Any ideas as to what lathe this may fit?
