Harrison Horizontal/Vertical Mill manual or dimensions

[angusb]

Hi,

I'm looking for a manual for a Harrison Horizontal/Vertical mill so I can find out the dimensions of the base and chip tray. This is so I can work out if I can move it using my 2 tonne engine crane, and whether it will fit in the space I'd like to put it in in my workshop. I don't want to end up buying one and then not being able to move it in the workshop so I need to know if the base will fit between the legs of my crane.

If anyone can point me to a pdf download of a manual for it that would be really helpful.

Thanks, Angus

 

[cheb]

I can measure mine tomorrow if nobody can so it sooner.

 

[Barking Mat]

Lathes.co.uk ?

 

[Agroshield]

Full manual is 14Mb, so too big to upload. Send an email address and you can have it that way.

Is there someone here who is a member of vintagemachinery.org (Smouser?)? Could I send the manual to whomever you are and you upload it there for posterity?

 

[angusb]

Thanks very much @Agroshield this is just what I needed. PM sent.

Cheers,

Angus

 

[cheb]

Are you sorted? Because I clean forgot to measure the thing this morning.

 

[angusb]

Are you sorted? Because I clean forgot to measure the thing this morning.

Yes thanks @cheb - got what I need now

 

[6ply]

I think it may be similar to my adcock and Shipley 1esg mill. Mine has a vertical head fitted and I leave the horizontal support arm fitted but slid right back out of the way. If you do this, you need to allow for the extra distance from the rear wall.

 

[angusb]

I think it may be similar to my adcock and Shipley 1esg mill. Mine has a vertical head fitted and I leave the horizontal support arm fitted but slid right back out of the way. If you do this, you need to allow for the extra distance from the rear wall.

Yes, that's it. It's got a horizontal overarm on a dovetail
.