steveo3002 Member Messages 7,675 Aug 8, 2011 #1 saw this on another forum http://www.jalopyjournal.com/forum/showthread.php?t=6015
E Engineer pre-moderated Messages 602 Aug 8, 2011 #2 Even easier for anyone who has a MIG set is to put a blob of weld on the end of the struck screw or bolt, and undo with a mole wrench while its still close to red heat.
Even easier for anyone who has a MIG set is to put a blob of weld on the end of the struck screw or bolt, and undo with a mole wrench while its still close to red heat.
Wozzaaah The wizard of woz Staff member Messages 17,537 Aug 8, 2011 #3 ^ Not ideal if you want to do your best to save that screw. I reckon that little tool is a cracking idea, good find Steve!
^ Not ideal if you want to do your best to save that screw. I reckon that little tool is a cracking idea, good find Steve!
