GYS SmartMIG 162 for Body panels?

[jamriggsy]

I am a nats whisker away from purchasing a GYS SmartMIG 162, But would just like to check that it would be suitable for bodywork on my honda crx which has very flimsy panel thickness, around 0.8mm i believe.
I would also like to have the option of welding bigger stuff up to about 5mm but my main use will be for repairing bodywork.

Any suggestions?,
Is this one a bit overkill for my needs?

P.S
I have searched and read the limited reviews that seem to be on here but there doesnt seem to be many

 

[Wozzaaah]

It will be fine on bodywork but if you're planning to do a lot of 5mm then you need to go much bigger than that.
It'll probably stick 5mm together ok but the duty cycle isn't high enough for heavy use so bear that in mind.

 

[jamriggsy]

sounds ok,
chances are it will only do very minor 5mm stuff.
i just didnt want compromise the body work side of things