johnakay
Member
- Messages
- 1,772
the blades in my guillotine(hand operated) about 9" in length.
seem a bit soft and worn, it still cut's but not cleanly.
I've sharpened them my self but it need a bit more off.
and I don't like the idea of putting a grinder to them.
I usually use a good file, I think it will take a bit more than that.
I foolishly cut some 8mm and 10mm bright round bar and it took the edge off.
is there any where I could get these resharpened and hardened.
seem a bit soft and worn, it still cut's but not cleanly.
I've sharpened them my self but it need a bit more off.
and I don't like the idea of putting a grinder to them.
I usually use a good file, I think it will take a bit more than that.
I foolishly cut some 8mm and 10mm bright round bar and it took the edge off.
is there any where I could get these resharpened and hardened.