Getting better I think

[cracker666]

M8 Captive nuts on 2mm plate
Sip 150DP
0.6mm Wire Setting 6 High high (updated)
Argonshield Light.

Welded too much on the top left and fixed the bolt in as well.
Breaker bar on the thing and snapped a 8.8 bolt, welded nut ok.

Ok penetration would be better with 0.8mm but only had 0.6 so make do.

 

[FranV8]

Looks good! What are they for?

 

[cracker666]

Homemade heater channel bottoms for a 1960 Karmann Ghia.
These are the captive nut thingys
cheers
http://www.vwheritage.com/vw_spares...hop.product_pID_150445_lang_EN_country_GB.htm

To buy £120.00 a side and in 4 parts.

 

[cracker666]

Update was settings were wrong so high I got bad burn back, stick out was twice as long as normal pulling back. otherwise I knackered another tip,

Still flat humm from mig and a wet puddle appeared.