Memmeddu
Member
- Messages
- 4,243
- Location
- Italia Sardegna
This morning i repaired this welder(sorry i have not picture), clean all, check rectifier.
Need to
fix the exaust (cracked)
change the sockets because they are to old and not CEE
So i would like change them whit CEE 400v and 230v, also dinse connector need to be changed.
Than a little bit of paint and hammerite for the fuel tank.
The engine works pretty good, it's a lombardini (intermotor koeler) 396cc i think between 12hp
Welder works good, and 230v output can drag a 2000w angle grinder.
I used 6013 electrode and works well.
No welding leads but it's not a problem.
How much can cost this welder?
Works well but need little mods to be better.
I have a budget of about 150€ but there is also 50 € of work on did this morning
It's enough, to much or it's a deal?
Thank you
Need to
fix the exaust (cracked)
change the sockets because they are to old and not CEE
So i would like change them whit CEE 400v and 230v, also dinse connector need to be changed.
Than a little bit of paint and hammerite for the fuel tank.
The engine works pretty good, it's a lombardini (intermotor koeler) 396cc i think between 12hp
Welder works good, and 230v output can drag a 2000w angle grinder.
I used 6013 electrode and works well.
No welding leads but it's not a problem.
How much can cost this welder?
Works well but need little mods to be better.
I have a budget of about 150€ but there is also 50 € of work on did this morning
It's enough, to much or it's a deal?
Thank you