RigspeedMatt
New Member
- Messages
- 1
Hi everyone,
I wondered if anyone on here could help. I have a fronius magicwave 1700 tig with a fault, it's coming up with error code 051 which I have been told is input voltage to low (NP24) not sure what the NP24 bit means?
I have tried various power supplies to the unit, it works intermitently then shuts down coming up with the 051 code.
any ideas?
any help would be much appreciated
thanks in advance.
Matt
I wondered if anyone on here could help. I have a fronius magicwave 1700 tig with a fault, it's coming up with error code 051 which I have been told is input voltage to low (NP24) not sure what the NP24 bit means?
I have tried various power supplies to the unit, it works intermitently then shuts down coming up with the 051 code.
any ideas?
any help would be much appreciated
thanks in advance.
Matt
