filters and air fed mask

[sixtwoeight]

With advice and recommendations from this forum I have run the pipework from my compressor around my workshop in 22mm copper with 4 drop legs to remove as much water as possible.
At the moment I havnt put a regulator in, this appears to go with the filters near the end of the line?
Can anyone recommend what filters I need to be able use an airfed mask for spraying 2K, also any ideas on which mask would be great. Am I also correct in saying that I need a different type of hose for breathing through?
As for budget. I want to spend as little as possible but need to obviously be safe, so I will have to spend what is necessary.
Many thanks in advance

 

[Daz1968]

Minimum is a standard filter regulator followed by a coalescing filter, then breathing quality hose to the belt pack, this should contain a carbon filter. If mask doesn't have a carbon filter you need to add one. As for mask its all down to what is on offer as a lot are basically the same but branded.