Hi all,
I was using the above welder recently and was getting a little cheesed off with having to have the lead almost straight to allow the wire to feed. I slid off the cover to tighten the wheel on the wire feeder, (already tight) put the cover back on and hey presto, the motor wont even try and turn! I removed the wire and still nothing apart from what sounds like a switch clicking when I squeeze the trigger.
Any ideas?
Cheers,
Mike
I was using the above welder recently and was getting a little cheesed off with having to have the lead almost straight to allow the wire to feed. I slid off the cover to tighten the wheel on the wire feeder, (already tight) put the cover back on and hey presto, the motor wont even try and turn! I removed the wire and still nothing apart from what sounds like a switch clicking when I squeeze the trigger.
Any ideas?
Cheers,
Mike