HasBean
Member
- Messages
- 467
Hi Guys,
I need to make up a cable to extend the power leads to my welders as they just won't quite reach the 16A socket on the wall
(Been using an old length of 2.5mm² artic flex so far)
Eventually I'll upgrade it to a 32A supply so I was thinking of some type of 4mm² (?) flex but does it need to be a particular type of flex ie heat resistant/rubber etc or will any sort do? BTW I was going to make the lead 4 or 5m long.
I need to make up a cable to extend the power leads to my welders as they just won't quite reach the 16A socket on the wall
(Been using an old length of 2.5mm² artic flex so far)Eventually I'll upgrade it to a 32A supply so I was thinking of some type of 4mm² (?) flex but does it need to be a particular type of flex ie heat resistant/rubber etc or will any sort do? BTW I was going to make the lead 4 or 5m long.
I've found the SY cable on t'internet. Will I be ok with 4mm or should I use 6?
