Paul William Addison
New Member
- Messages
- 5
- Location
- Newcastle
I have a Clarke 151en which is adequate for sheet metal for car restoration however I've been upgrading a few things, better regulator and better earth cable. So I bought a euro torch conversion assumed there was a gas solenoid inside the set but have found it's trigger actuated. I thought I could use the wire feed unit wires for the solenoid however watching a few youtube videos it seems a little more complicated and the drive motor probably won't powerful enough for the 4m torch.
After being a welder in the oil and gas industry for over 40 years you would think I'd know better that I really should have bought something a bit better.
After being a welder in the oil and gas industry for over 40 years you would think I'd know better that I really should have bought something a bit better.