Elliott Omnimill slotting attachment wanted

[aviv]

Hi everyone,

I’m looking for a slotting attachment for my Elliott Omnimil 00. If anyone has a lead, please contact me either here or by email:
Mod edit: email address removed

Thanks.

 

[RichardM]

You'd be better off messaging than attaching your email

 

[Milkybars]

Be prepared for deep pockets, is it the 3MT or 30int on the horizontal ...

 

[aviv]

Be prepared for deep pockets, is it the 3MT or 30int on the horizontal ...

If too deep, I can get a new mill…
Fortunately It’s 30int.

Aviv.

 

[fizzy]

I have one for my Elliott Sturdimill - not sure what fitting and if it would fit at all. What is the bolt circle diameter etc on yours? I can measure it up. But I suspect mine is int40 or 50.

 

[gaz1]

you can make one but it depends on which model that you have

i have the bar on my model not an omnimill which means i fix to that and use the original morse taper to drive the slotting attachment

internal

external
external is also easier to adjust the stroke depth

both are driven by the mills drive system through there taper system but my bar holds the slotting adapter straight

 

[Milkybars]

when I have seen them for sale they have been in the £250 to 400 range and they are pretty rare
I have a 3MT version of the head ..that doesn't fit my 30int Omnimill ...so if you find one ensure its 30int

Fizzy the Sturdimill is a much bigger beast

 

[fizzy]

when I have seen them for sale they have been in the £250 to 400 range and they are pretty rare
I have a 3MT version of the head ..that doesn't fit my 30int Omnimill ...so if you find one ensure its 30int

Fizzy the Sturdimill is a much bigger beast

Yes it is very aptly named