I have an Eland MIG 130, and the wire feed has just failed. I hadn't used the machine for a few months, and at first it would only run the wire very slowly. After about a minute, it started working normally, and I could adjust the speed using the control, but it seemed to be struggling to feed the wire. A bit later on it went to full speed, and the speed control now has no effect. The timer controls still work as normal, though.
Any ideas what the problem might be? Is there anyone that could service the drive board?
It's a good solid welder, so I don't really want to scrap it.
Any ideas what the problem might be? Is there anyone that could service the drive board?
It's a good solid welder, so I don't really want to scrap it.