drive rolls

[patreusch]

im switching from flux to solid from .035 to .023 do i have to change the drive rolls and how and anything besides gas and polarity?
about 18 cfh right?
and best way to hook regulator to the little line on my regulator my regulator has about half inch line coming off it

 

[shenion]

You need to reverse the drive roller for 0.023

18CFH is fine.

Most regs have a 5/8"-16 flahed output. On mine, I unscrewed the output fitting from the regulator and then installed a 1/4" NPT fiting with a 3/16" nipple. Then used some 1/8 vacuum line to connect from the nipple to the 4mm line from the reg (if you can find 5/32 or 4mm vacuum line it will work better..

 

[patreusch]

any info on how to flip the drive roller i dont see how to take it off without a lot of screws

 

[shenion]

There is a set screw between the grooves.

 

[patreusch]

thanks a lot