- Messages
- 23,260
- Location
- Birmingham
As usual one job leads to another 
Changing the CV boots on the quad and one of the bearings escaped to the darkest reaches of the garage so I took the rest out to save losing them and they are in poor condition so I'm going to replace the lot.
found these and would like to know if they are the right material, hardness etc.?
Not going to replace the complete joint as the cheapest I can find is over $200 in the US, hate to think what they would cost here

Changing the CV boots on the quad and one of the bearings escaped to the darkest reaches of the garage so I took the rest out to save losing them and they are in poor condition so I'm going to replace the lot.
found these and would like to know if they are the right material, hardness etc.?
Not going to replace the complete joint as the cheapest I can find is over $200 in the US, hate to think what they would cost here
