Welding some uprights on my trailer. 50x50x6mm angle end on to a hefty section of C channel.
I was so careful and then it pulled slightly on the last weld.
I put a nice heavy bead the other side and now it is bang on - BUT that weld can't be there. If I grind it off again will it stay straight or is it likely to go back to how it was?
I
I was so careful and then it pulled slightly on the last weld.
I put a nice heavy bead the other side and now it is bang on - BUT that weld can't be there. If I grind it off again will it stay straight or is it likely to go back to how it was?
I