Connectors for C02

[daveball]

I've had in my collection of junk 2 Pub C02 cylinders with liquid still inside. I've also got a Nitogen cylinder with a regulator that I once used for powering a low pressure compressed air actuator when away from a power supply of any kind. Photos of both attached. Can anyone tell me if I can get adaptors to mate the C02 cylinder to the regulator and would the set up work for MIG. The fitting on the C02 tap seems to be slightly bigger than 1/2" BSP, with a right hand thread. I assume I would mate to the reg and gauges at the small fitting size screwed into the reg body,(1/4 BSP??).

Dave

 

[clownfish]

Re connectors for co2

yes you can get an adapter to screw into your regulator i have one but it still
depends on the thread into your regulator there are a couple of thread types
co2 mind is not the best for welding why dont you use argoshield much better
for welding hope this helps clownfish (pm me about the adapter)