Clarke 180EN manual..?

[Radius]

The 180EN is not among those listed on the Clarke service/manual page, so I wanted to ask if perhaps someone had a copy of the PDF they could give/point me towards?

The welder was donated to my son's school, and I'm attempting to go through it, and check it for parts & functionality.

Thanks much,

Ray~

 

[mike 109444]

If you post a pic of the welder (front and insides) it could be that it is similar enough to other models such that another manual could be used. Clarke tend to use the same components across several models hence when you look at some of the other welders the manual will cover several machines.
And welcome BTW

 

[gaz1]

the closest match to yours is the mig 160en manual

http://www.clarkeservice.co.uk/manuals/mig_welders/mig110e-160en.pdf

as reference to the power rating id use this as it

http://www.clarkeservice.co.uk/manuals/mig_welders/mig165_175te.pdf

yours will be the international version

http://www.mig-welding.co.uk/forum/threads/clarke-180en-mods-need-advice.36331/

 

[Radius]

I thank you both, and apologize for my delay in responding- there was some issue reloading the forum, though I'm still uncertain as to why.

Regardless, I had looked over the 160en manual, and will take a look at the same for the 165 & 175te

Thanks again,

Ray~

 

[mike 109444]

Hope you find what you are looking for
Any problems then post up Q's