clarke 175te: torch fitment/ wire feed

[jopro]

Does anybody have a photo of how the torch attaches to the welder, the part underneath the litle plastic cover on the wirefeed?
Im not sure if im trying to put it together correct as there either isnt enough thread or the liner goes between the rollers.

Probably real simple!

Cheers

 

[weldequip]

Just PM'd you
The Liner needs trimming a touch. Make sure it is almost touching the bottom wire feed roller before cutting it with a good pair of wire-snips/pliers.
weldequip

 

[jopro]

You mean it should nearly touch after it's cut?

 

[weldequip]

Yes. As close as you can, almost touching the bottom feed roller. Obviously, if it's actually touching the roller it could hinder feed, but if it's cut too short the wire has more chance of 'bird's nesting'
weldequip

 

[shenion]

You can also grind a the end to a V so it gets real close. Virtually eliminates the chance of birdsnesting. A must if you do aluminum.

 

[jopro]

All sorted now, cheers!