Clarke 151EN, controller capacitor? missing

[ElderWelder]

Hi all, was gifted (after fixing a £600 truck component!) above machine and found that a component is missing from the controll board, probably a capacitor. The board ref is P 91345-0507 PCB etch 177254.1 E 1292.01.

The two holes are 8mm apart and the (missing) component is at bottom edge of board (cables at top) see red flag on picture.

Would greatly appreciate value of missing component, machine looks well used and fan turns when switched on so worth some attention.

Thanks in advance.

 

[keith19]

There is a cap there, 1000uf, 35v. The pic below is from a 100EN wire feed pcb used on another thread.
Check out how close it is to yours before replacing cap; would think they would have similar values.
Edit: I have just checked on my own 151EN, and the values above are correct: 1000uf 35v. Mine is a Daewoo cap, as it happens, but any decent brand should do.

 

[keith19]

Another pic, this time of my own 151EN wire feed board:

 

[ElderWelder]

Keith19

Thanks for excellent response, will procure capacitor.

 

[mike 109444]

ElderWelder Once you have replaced cap ask yourself why was it removed? If I have to work on any sus kit (unless at work) then I would plug it in via one of thoses trip type devices like they recomend for lawnmowers ect (some extension leads have then built in) That way youhave some protection when you first power it on. Note the trip device will prob trip if you try to weld with it still connected but it's a good first power up protection. Or stand well back and light blue touch paper : )