Clarke 135 TE

[BenKeeling]

Is it possible to use a clarke 160TE torch setup on my 135TE? Just my torch needs replacing and the 160TE is longer in cable length.

 

[Wedg1e]

I doubt it'd be IMpossible, just depends on how far you have to go when changing bits.

 

[BenKeeling]

I doubt it'd be IMpossible, just depends on how far you have to go when changing bits.

My worry is would the wire feed motor struggle with the extra half meter of cable?

 

[Wedg1e]

My worry is would the wire feed motor struggle with the extra half meter of cable?

Hard to say; ideally you aim to keep as straight a run on the cable as possible and presumably the extra reach is what you're after! There should be minimal drag from the liner if it's in good order.