circular saw blades

[JayRS4]

Has anyone any recommendations of where to buy wet cut circular saw blades, like this http://www.weldmet.co.uk/product_info.php/products_id/3011 . I can`t remember the size I actually need, it is only a baby as these saws go, probably around 8". I`ve just had one shatter when it snatched up the offcut.

Luckily i have a spare (slightly smaller), but that could do with a sharpen too, so if anyone has a recommendation of people that can sharpen as well.

Preferably in the Surrey/Sussex/Hampshire area, I prefer to build relationships with actual people and companies rather than web stuff, plus it give me a chance to look at all the other things I dont really need at the same time

 

[Archie]

I've got about 30 of 'em in varying sizes and they're all sharp. No way I'm going to use all of them so you'd be welcome to a couple, especially if they're the smaller ones you're after. Downside is I'm not going to be about until mid-December but if you can wait...

 

[JayRS4]

Thats very kind of you Archie, i`ll have a look tommorow at what size they are. No rush, i`ve got the spare, just let me know when your back and i`ll sort out some beer tokens

 

[Archie]

No probs Jay. Let me know the size and when I'm next home I'll see what I can find.

 

[JayRS4]

The broken one was a 200x2.5x32 z160, so around that size. A 225 would fit, teeth anywhere from 160-220 would be good. The spare I have has been sharpened so many times it`s lost an inch in diameter! Thanks Archie, appreciate your help

 

[Archie]

The ones I have have mostly been sharpened quite a bit so are also much smaller than the sizes printed on them dictate. But... I've got them in sizes from 315mm down so I'm sure I'll find something around the same size. I'll PM you.

 

[Archie]

Finally got round to having a look. I've got 3 of roughly 220mm dia. That you're welcome to. 2 are 2.5mm and the other is 2mm. They're all 220 teeth with a 32mm centre hole. Like I said, they've been reground a few times - they started life 300mm dia.!

 

[JayRS4]

Brilliant, pm on its way