changing a liner on a 160en

[choco]

is it meant to be that you have to take off the whole cover of the welder to take off the plastic cover on the wire feed motor. There are two long screws that thread through to the other side of the welder(where the circuit board and transformer are)with bolts. When you losen the screws the bolts just spin. needing access to the other side to grip the bolts from spining and enabling the screws to thread out. This seems very time consuming just to change a liner??

 

[optima21]

sounds about right, on my 151te I cut the plastic part in 2, and it appears to work as well, but much easier to change liners

 

[choco]

Thanks ill do the same as its a pain to change when you have to remove the whole cover