Centre Drill

[rosinante]

Hi all is there any one in or near Gillingham Kent with a lathe with a headstock bore of 30 mm or greater that could centre drill the end of a bench screw for me, the bench screw was recovered from a joiners bench in Grytviken South Georgia in 1982, have finally got round to building a bench for it.
The reason for the centre drill is to allow me to mount it on my little lathe and slightly modify it to provide a bearing surface for a "garter".
Here's hoping
thanks for reading
Chris

 

[awemawson]

Not measured it, but the spec says my Colchester Master 2500 has a 40 mm bore.

If TN33 0RG is close enough for you pop down and I'll do it for you

 

[scott0031]

Yes but you may have to be patient, I'm pretty busy at the moment,

Pm me if i can be any help.

 

[rosinante]

Not measured it, but the spec says my Colchester Master 2500 has a 40 mm bore.

If TN33 0RG is close enough for you pop down and I'll do it for you

Thanks for quick offer, bit too far away though,
Cheers
Chris