Hi again everyone I own a castomag 150 mig which is a very old but very good welder unfortunately it has not been used more than once in the last 12 months and I went to use it yesterday and it has developed a fault the wire is not stuck as I can pull it through with pliers but it is not feeding through so I would welcome any suggestions on how to bring it back to life when the gun trigger is pulled you hear one loud click as normal but no wire feed the gas is feeding many thanks Chris
- Thread starter chrisf1
- Start date
mike 109444
Member
- Messages
- 4,796
There is mention in the manual of "fuses" on the pcb. might be worth looking there first. Failing that look at the back of the feed motor to see if the two wires are on the motor.
